Bobcat 743 - Page 22

j
A fter the loader is on the transport
vehicle, follow this procedure:
1. Lower the bucket or attachment to
the floor and stop the engine.
2. Engage the parking brake.
3. I nstall chains to hold the Bobcat
loader in position to prevent it from
moving during sudden stops or
when going up and down slopes.
4. Put a chain through the axle gusset
and fasten to the Bobcat loader
and to the trailer (Fig. 32).
5. Fasten chains, one in each upright
cutout, to the loader and to the
trailer (Fig. 33).
LIFT ARM STOP (Fig. 34)
Fig. 32 Fastening the Loader
NOTE: Lift arm stops are available at your local Bobcat dealer.
1. Two (2) persons are needed to install the lift arm stop. One person must be in
the operator's seat, with the seat belt fastened, until the lift arm stop is
installed.
2. Start the engine and raise the lift arms all the way up.
3. Have the second person install the lift arm stop over the rod of one lift cylinder.
NOTE: Make sure the lift arm stop is tight against the cylinder rod.
4. Lower the lift arms until the stop is held between the lift arms and the lift
cylinder.
5. Stop the engine.
-16-
Fig. 33 Fastening Loader
Fig. 34 Lift Arm Stop
6558015
743 Loader
Operator's Manual