152 S130 Operation & Maintenance Manual
LOADER STORAGE AND RETURN TO SERVICE
Storage
Sometimes it can be necessary to store your Bobcat
loader for an extend period of time. Below is a list of items
to perform before storage.
• Thoroughly clean the loader including the engine
compartment.
• Lubricate the loader.
• Replace worn or damaged parts.
• Park the loader in a dry protected shelter.
• Lower the lift arms all the way and put the bucket flat
on the ground.
• Put blocks under the frame to remove weight from the
tyres.
• Put grease on any exposed cylinder rods.
• Put fuel stabilizer in the fuel tank and run the engine
a few minutes to circulate the stabilizer to the pump
and fuel injectors.
If biodiesel blend fuel has been used, perform the
following:
Drain the fuel tank, refill with 100% petroleum diesel
fuel, add fuel stabilizer and run the engine for at least
30 minutes.
• Drain and flush the cooling system. Refill with
premixed coolant.
• Replace all fluids and filters (engine, hydraulic /
hydrostatic).
• Replace air cleaner, heater and air conditioning filters.
• Put all controls in neutral position.
• Remove the battery. Be sure the electrolyte level is
correct then charge the battery. Store it in a cool dry
place above freezing temperatures and charge it
periodically during storage.
• Cover the exhaust pipe opening.
• Tag the machine to indicate that it is in storage
condition.
Return To Service
After the Bobcat loader has been in storage, it is
necessary to follow a list of items to return the loader to
service.
• Check the engine and hydraulic oil levels; check
coolant level.
• Install a fully charged battery.
• Remove grease from exposed cylinder rods.
• Check all belt tensions.
• Be sure all shields and guards are in place.
• Lubricate the loader.
• Check tyre inflation and remove blocks from under
frame.
• Remove cover from exhaust pipe opening.
• Start the engine and let run for a few minutes while
observing the instrument panels and systems for
correct operation.
• Operate machine, check for correct function.
• Stop the engine and check for leaks. Repair as
needed.
To Next Page
Loading...