AVOID INJURY OR DEATH
• Engines can have hot parts and hot exhaust gas.
Keep flammable material away.
• Do not use machines in atmosphere containing
explosive gas.
W-2051-1086
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 73.)
Figure 93
Set the engine speed control to the idle position [Figure
93]
NOTE: Loaders with a Keyless Start Panel have a
permanent, randomly generated Master
Password set at the factory. Your loader will
have an Owner Password. The password can
be changed to prevent unauthorised use of
your loader. (See Changing The Owner
Password on Page 163.) Keep your password
in a safe place for future needs.
NOTE: The Password Lockout feature can be used to
allow starting of the loader without a
password. (See Password Lockout Feature on
Page 163.)
Figure 94
Press the RUN button (Item 3) [Figure 94].
Use the numeric keypad (Item 1) to enter the password,
then press the RUN button (Item 3) [Figure 94].
Figure 95
The machine will cycle the air intake heater (glow plugs)
automatically based on temperature. The engine preheat
icon (Item 1) will be ON and the cycle time remaining will
show in the data display (Item 2) [Figure 95].
When the engine preheat icon goes OFF, press the
START button (Item 2) [Figure 94]. Release the button
when the engine starts.
To Next Page
Loading...