AVOID SERIOUS INJURY OR DEATH
• Engines can have hot parts and hot exhaust gas.
Keep flammable material away.
• Do not use machines in atmosphere containing
explosive dust or gases.
W-2051-0212
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 94.)
Figure 113
Set the engine speed control to the low idle position
[Figure 113].
NOTE: Loaders with a Deluxe Instrumentation Panel
have a permanent, randomly generated
Master Password set at the factory. Your
loader will also be assigned an Owner
Password. Your dealer will provide you with
this password. Change the owner password
to one that you will easily remember to
prevent unauthorised use of your loader. (See
Changing The Owner Password on Page 212.)
Keep your password in a safe location for
future needs.
NOTE: The Password Lockout feature can be used to
allow starting of the loader without a
password. (See Password Lockout Feature on
Page 213.)
Figure 114
Turn the key switch to RUN (Item 2) [Figure 114]. The
indicator lights on the left instrument panel will come ON
briefly and the instrument panel / monitoring system will
perform a self test.
Use the numeric keypad (Item 1) [Figure 114] to enter
the password.
Figure 115
The machine will cycle the glow plugs automatically
based on temperature. The engine preheat icon (Item 1)
and the cycle time remaining (Item 2) [Figure 115] are
displayed in the data display.
When the engine preheat icon goes OFF, turn the key
switch to START (Item 3). Release the switch when the
engine starts and allow the switch to return to the RUN
position (Item 2) [Figure 114].
To Next Page
Loading...