118 S450 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Levelling The Ground Using Float (Foot Pedals)
Figure 146
Standard Controls
Put the lift arms in float position by pushing the pedal all
the way forward (Item 1) [Figure 146] until the pedal is
locked into the forward position.
ACS In Foot Pedal Mode
Press and hold the Float button (Item 4) on the left
handle while the left pedal is in neutral. While lowering
the lift arms (Item 1) [Figure 146], release the Float
button.
Standard Controls And ACS In Foot Pedal Mode
Tilt the bucket forward (Item 2) [Figure 146] to change
the position of the cutting edge of the bucket.
With the bucket tilted farther forward, there is more force
on the cutting edge and more loose material can be
moved.
Drive backward to level loose material.
Push the bottom of the pedal (Item 3) [Figure 146] to
unlock the float position.
NOTE: On ACS equipped loaders in Foot Pedal Mode,
pressing the Float button again will disengage
float.
To Next Page
Loading...