AVOID INJURY OR DEATH
Instructions are necessary before operating or
servicing machine. Read and understand the
Operation & Maintenance Manual, Operator’s
Handbook and signs (decals) on machine. Follow
warnings and instructions in the manuals when
making repairs, adjustments or servicing. Check for
correct function after adjustments, repairs or
service. Untrained operators and failure to follow
instructions can cause injury or death.
W-2003-0807
Every 10 Hours (Before Starting The Loader)
• Engine Oil – Check level and add as needed. (See Page 161.)
• Engine Air Filters and Air System – Check display panel. Service only when required. Check for leaks and damaged
components. (See Page 154.)
• Engine Cooling System – Clean debris from hydraulic fluid cooler and radiator assembly, air conditioning condenser
(if equipped), and rear grille. Check coolant level COLD and add premixed coolant as needed. (See Page 164.) and
(See Page 167.)
• Fuel Filter – Remove the trapped water. (See Page 158.)
• Lift Arms, Lift Links, Cylinders, Bob-Tach, Pivot Pins, Wedges – Lubricate with multipurpose lithium based grease.
(See Page 193.)
• Seat Belt, Seat Belt Retractors, Seat Bar, Control Interlocks – Check the condition of seat belt. Clean or replace
seat belt retractors as needed. Check the seat bar and control interlocks for correct operation. Clean dirt and debris
from moving parts. (See Page 138.) and (See Page 140.)
• Bobcat Interlock Control Systems (BICS™) – Check for correct function. Lift and Tilt functions MUST NOT operate
with seat bar raised. (See Page 137.)
• Front Horn – Check for proper function. (See Page 57.)
• Tyres – Check for damaged tyres and correct air pressure. Inflate to MAXIMUM pressure shown on the sidewall of
the tyre. (See Page 186.)
• Operator Cab – Check the fastening bolts, washers, and nuts. Check the condition of the cab. (See Page 146.)
• Indicators and Lights – Check for correct operation of all indicators and lights. (See Page 46.)
• Wheel Nuts – Perform every 10 hours or daily for the first 30 hours, then as scheduled. Check for loose wheel nuts
and tighten to correct torque. (See Page 186.)
• Safety Signs and Safety Treads – Check for damaged signs (decals) and safety treads. Replace any signs or safety
treads that are damaged or worn. (See Page 26.) and (See Page 94.)
• Hydraulic Fluid – Check fluid level and add as needed. (See Page 176.)
• Heater and Air Conditioning Filters (if equipped) – Clean or replace filters as needed. (See Page 151.)
To Next Page
Loading...