75 S450 Operation & Maintenance Manual
SPEED MANAGEMENT
Speed Management is available on SJC equipped machines.
Description
Speed Management allows the loader to be manoeuvred at a slower travel speed, even during maximum movement of the
joystick(s).
This feature can be useful when installing attachments, loading or unloading, and certain applications. (EXAMPLES:
Landscaping, tilling, trenching)
Operation
NOTE: Two-Speed Loaders Only – You must be in low
range speed to engage Speed Management.
Figure 64
Press the button (Item 1) [Figure 64] on the left joystick
once to engage Speed Management.
Figure 65
The Speed Management icon (Item 1) [Figure 65] will
appear in the display and remain on until the Speed
Management button is pressed again or the machine is
turned off.
When Speed Management is engaged, the machine will
travel at the factory default setting of 57% of Standard
Travel Speed and the percentage [SPD 57] will appear in
the display (Item 2) [Figure 65].
NOTE: The factory default setting can be changed by
the operator. (See Changing The Factory
Default Setting on Page 76.)
While Speed Management is engaged, press the top of
the Speed Control switch (Item 2) [Figure 64] to increase
the speed up to 99% [SPD 99] or the bottom of the switch
(Item 3) [Figure 64] to decrease the speed down to 1%
[SPD 01]. The percentages will appear in the display
(Items 2, 3, and 4) [Figure 65].
Press button (Item 1) [Figure 64] again to disengage
Speed Management and return to Standard Travel
Speed. [STD] (Item 5) [Figure 65] will appear in the
display.
The system will retain the speed percentage as long as
the loader remains ON.
EXAMPLE: You can be using the machine at 40%,
then disengage Speed Management to reposition
the loader, and then reengage Speed
Management. The speed percentage will still be at
40%.
EXAMPLE: Turning the key switch to STOP will
return the Speed Management setting to default.
The next time you start the engine and engage
Speed Management, the speed is set at 57%
(factory default setting) or the last default setting
saved by the operator. (See Changing The Factory
Default Setting on Page 76.)
NOTE: Two-Speed Loaders Only – You must
disengage Speed Management before you
can select high range.
To Next Page
Loading...