93 S450 Operation & Maintenance Manual
DAILY INSPECTION (CONT’D)
Daily Inspection And Maintenance (Cont’d)
The following list of items must be checked daily:
• Engine Oil Level
• Hydraulic Fluid Level
• Engine Air Cleaner – Check System for Damage or
Leaks
• Engine Cooling System – Check System for Damage
or Leaks, Check Coolant Level, Clean Hydraulic Fluid
Cooler and Radiator Assembly, and Rear Grille
• Operator Cab and Cab Mounting Hardware
•Seat Belt
• Seat Bar and Control Interlocks
• Bobcat Interlock Control System (BICS™)
• Front Horn – Check for Proper Function
• Grease Pivot Pins (Lift Arms, Lift Links, Bob-Tach,
Cylinders, Bob-Tach Wedges)
• Tyres – Check for Wear, Damage, Correct Air
Pressure
• Fuel Filter – Remove Trapped Water
• Loose or Broken Parts – Repair or Replace as
Necessary
• Safety Treads and Safety Signs (Decals) – Replace
as Necessary
• Lift Arm Support Device – Replace if Damaged
This machine is factory equipped with a spark
arrester exhaust system that must be maintained for
proper function.
• WITH MUFFLER
The muffler chamber must be emptied every 100
hours of operation to keep it in working
condition.
• WITH DIESEL OXIDATION CATALYST (DOC)
Do not remove or modify the DOC.
• WITH DIESEL PARTICULATE FILTER (DPF)
The DPF must be maintained according to the
instructions in the Operation & Maintenance
Manual for proper function.
(If this machine is operated on flammable forest,
brush or grass cover land, a spark arrester attached
to the exhaust system may be required and must be
maintained in working order. Refer to local laws and
regulations for spark arrester requirements.)
I-2350-EN-0813
PRESSURE WASHING DECALS
• Never direct the stream at a low angle toward the
decal that could damage the decal causing it to
peel from the surface.
• Direct the stream at a 90 degree angle and at
least 300 mm (12 in) from the decal. Wash from
the centre of the decal toward the edges.
I-2226-EN-0910
To Next Page
Loading...