bObi CLASSIC - Bobi Mailbox Mounting Procedures; Mounting to Walls and Fences; Mounting Through Fences; Mounting on BOBI ROUND Stand

MOUNTING INSTRUCTIONS
Mounting a BOBI mailbox to a wall or fence
Drill out the 4 preformed holes which are in the back of
the mailbox using a ¼ or 6 mm drillbit.
Attention! Holes should be drilled with a low speed
drill ( maximum 500 rpm ) and on stainless steel
mailboxes it is recommended to use a drillbit made
from hardened steel.
Fix the mailbox from inside using the 4 screws provided.
Mounting a BOBI mailbox through a fence
Drill out the 4 preformed holes which are on the side of
the mailbox using a ¼ or 6 mm drillbit.
Attention! Holes should be drilled with a low speed
drill ( maximum 500 rpm ) and on stainless steel
mailboxes it is recommended to use a drillbit made
from hardened steel.
Fix the mailbox from inside using the 4 screws provided.
Mounting a BOBI mailbox on a BOBI ROUND stand
Before installing the
mailbox to the curbside
see the instructions on
the reverse side to
ensure its correct
placement and height
at the street.
1. Drill out the 4 preformed holes which are on the side of the mailbox using a ¼ or 6mm drillbit.
Attention! Holes should be drilled with a low speed drill (maximum 500 rpm) and on stainless
steel mailboxes it is recommended to use a drillbit made from hardened steel.
2. Fasten the mailbox to the stand using the fittings provided.
3. Dig a hole ca. 17 x 17 x 17. Place the mailbox and stand in the ground, check the level and fill
the hole with coarse gravel or concrete. We recommend using a quick set concrete for a secure
and solid installation.