O2 Vibe Wrist Pulse Oximeter
The O2 Vibe Pulse Oximeter can monitor whole night blood oxygen
saturation (SpO
2
) and heart rate and detect oxygen drops. The built-in
vibrator can help people to overcome the oxygen shortage period,
therefore to improve their sleep quality. O2 Vibe can also be used for
fitness monitoring and activity tracking.
This product is not a medical device, DO NOT use it for the diagnosis
and treatment of any medical condition.
Using O2 Vibe Pulse Oximeter
Charge the battery before the first use
Connect the battery using the USB cable provided for about 2 hours or
until the screen shows fully charged icon .
Download and install the app
O2 Vibe
from the Apple APP Store or
Press and hold the button for 1 second to power on the device, 3
seconds to power off the device.
View results and set preferences via APP
After each measurement or when you turn on the device, the results
can be provided in the APP on your phone via
Bluetooth.
Turn on the
Bluetooth
of your phone, enter the
O2 Vibe
app and choose the right
device, then the device and your phone will connect successfully. You
can switch on/off vibration, adjust intensity and threshold (SpO
2
) of
vibration, and set steps goal in the app.
Note:
The device
Bluetooth
will automatically turn on within the first
2 minutes. Or it turns on after measurement complete until power off.
1. Connect the ring sensor to the connector on
2. Wear the ring sensor into your thumb as
picture or other finger in the case of not fitting
3. Press the button to turn on the device,
change the mode by press the button in the first
4 seconds if necessary. After a few seconds, your
SpO
2
reading will appear on the screen.
SpO
2
Percent oxygen saturation
Insert the plug into the connector on the device
Slide your finger into the sensor
O2 score and Drop times (SpO
2
lower than threshold)
O2 Score range in the APP
To Next Page
General
