Body Solid VDRA30 - Step 1: Assemble Legs

6
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step unless otherwise noted.
A. Insert Foot Caps (8) into Legs (B). (pre-installed)
B. Connect both Legs (B) to Main Body (A) using:
Four 11 (M8x40 hex head bolt)
Four 12 (M8 washer)
NOTE: Align Legs (B) in the same direction as shown in the
diagram.