The Bogen Model FMR is a wall-mounting FM radio designed to furnish

background music in paging systems and for music-on-hold applications.

It operates from a 12V DC or 24V DC power source and has a line-level

output for connection to a paging amplifier or paging control device. A separate

1-watt output is provided to drive an external amplifier speaker.

A tuning dial selects the desired frequency. A built-in speaker facilitates

tuning and AFC circuitry prevents signal drift. A screwdriver-adjustable tone

control and separate volume controls are provided for the outputs. Switches

select power ON/OFF, internal or external antenna (telescoping antenna or

external 300-ohm), AFC ON/OFF, and internal or external speaker (1-watt

output). Screw terminals are included for connection of external antenna,

24V DC power supply, and outputs. A jack is provided to connect a receptacle-

mount 12V DC power supply (not included - PRS40C recommended).

Specifications subject to change without notice.

54-5893-01B 1109

Tuning Range: ............................87.5 MHz to 108.5 MHz

FM Sensitivity: ............................8mV

Frequency Response: ................90 Hz to 16 kHz, +2dB

Power Output: ............................1-watt @ 8-ohms; 100 mW (Line Out)

Signal-to-Noise Ratio: ................-65dB

Distortion: ..................................Less than 2% at rated power output

Power Requirements: ................12V DC or 24V DC; 250 mA

Dimensions: ................................3-3/8” W x 6” H x 1-1/2” D

Product Weight: ........................1 lb.

SPECIFICATIONS

FMR

FM Radio Receiver

50 Spring Street, Ramsey, NJ 07446, U.S.A.

Tel. 201-934-8500 • Fax: 201-934-9832

www.bogen.com

The Bogen FMR FM Radio Receiver is warranted to be free from defects in material and workman-

ship for two (2) years from the date of sale to the original purchaser. Any part of the product covered

by this warranty that, with normal installation and use, becomes defective (as confirmed by Bogen

upon inspection) during the applicable warranty period, will be repaired or replaced by Bogen, at

Bogen’s option, provided the product is shipped insured and prepaid to: Bogen Factory Service

Department, 50 Spring Street, Ramsey, NJ 07446, USA. Repaired or replacement product will be

returned to you freight prepaid.This warranty does not extend to any of our products that have been

subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have been

modified or repaired or altered in any manner whatsoever, or where the serial number or date code

has been removed or defaced.

THE FOREGOING LIMITED WARRANTY IS BOGEN’S SOLE AND EXCLUSIVE WARRANTY

AND THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY. BOGEN MAKES NO OTHER

WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, AND ALL IMPLIED WAR-

RANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY

DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY LAW. Bogen's

liability arising out of the manufacture, sale or supplying of products or their use or disposition,

whether based upon warranty, contract, tort or otherwise, shall be limited to the price of the product.

IN NO EVENT SHALL BOGEN BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL

DAMAGES (INCLUDING, BUT NOT LIMITED TO, LOSS OF PROFITS, LOSS OF DATA OR LOSS

OF USE DAMAGES) ARISING OUT OF THE MANUFACTURE, SALE OR SUPPLYING OF

PRODUCTS, EVEN IF BOGEN HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH

DAMAGES OR LOSSES. Some States do not allow the exclusion or limitation of incidental or

consequential damages, so the above limitation or exclusion may not apply to you. This warranty

gives you specific legal rights, and you may also have other rights which vary from State to State.

Products that are out of warranty will also be repaired by the Bogen Factory Service Department –

same address as above or call 201-934-8500. The parts and labor involved in these repairs are war-

ranted for 90 days when repaired by the Bogen Factory Service Department. All shipping charges

in addition to parts and labor charges will be at the owner's expense. All returns

require a Return Authorization number. For most efficient warranty or repair service, please include

a description of the failure.

12/2008

Limited Warranty; Exclusion of Certain Damages

Bogen FMR - Page 4

Other manuals for Bogen FMR

Related product manuals