Device: Bolin VCC-7HD30S-3SMN
Introduction
A large number of parameters can be controlled on the Bolin VCC-7HD30S-3SMN. Control is via VISCA
over IP (and not NDI). The Device Core is still in beta with few bugs to get sorted out.
Please notice currently the Bolin camera do not support block inquiry commands over IP, so not all current
settings on the camera will be transmitted back to our controllers. Examples
-
When our controller connects to the camera some settings will not be in sync with the actual state of the
camera. The shutter speed on our controller could reflect one setting, while the actual shutter speed on
the camera could be different until the shutter speed has in fact been set from our controller
-
If multiple SKAARHOJ controllers are connected to the same camera they will not be in sync, and
control might not be possible
-
If changes are made in the OSD these will not necessarily be reported back to the SKAARHOJ
controller
The implementation is done on Bolin VCC-7HD30S-3SMN Firmware version:
To Next Page
Need help?
General
