GB
40
Steam Ironing
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity regulator (4).
no steam
Small steam volume
Large steam volume
Steam Jet
• Turn the button (5) to the steam jet symbol.
• Then press the button (5) for the steam jet.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Note: To avoid excess water leaking from the soleplate do not operate the steam
burst for more than 5 seconds without interruption.
Caution: the steam is hot. Danger of scalding!
When ironing at low temperatures, make sure that you reduce the quantity of
steam or iron without steam. If the temperature is too low water may leak from the
soleplate.
Refi lling the water tank
• Always disconnect the mains plug before refi lling water.
• Set the steam control (4) to “
” (no steam). Open the lid of the refi ll inlet (6)
and carefully pour in the water. Do not exceed the maximum line as marked on
the water reservoir.
Spray Function
• Turn the button (5) to the spray symbol.
• In order to moisten a section to be ironed press the spray button (5).
Cleaning and Storage
• Always remove the mains lead before cleaning!
• Clean the casing with a slightly damp cloth.
• Clean the iron with a slightly humid cloth.
• Always return the steam regulator to the „
“ position after use and empty
the water tank in order to prevent any leaks.
05-DB 2988 40 24.05.2005, 11:15:21 Uhr
To Next Page
Loading...
