BOMANN KG 7321 - Page 28

28
sumption. Enough clearance is nec-
essary.
- Gap to the back and to the side
walls each approx. 10 cm;
- Place the appliance so that the ap-
pliance door can open without being
impeded.
• Only install at a location with an am-
bient temperature suitable for the cli-
mate class of the appliance. For in-
formation on the climate class, please
refer to the “EU Product Data Sheet”
or to the rating label located in the in-
terior or on the appliance rear.
• Place the appliance on a steady and
safe surface. If the appliance is not
horizontally leveled, adjust the feet
accordingly.
• Av
AvAv
Avoid t
oid toid t
oid the install
he installhe install
he installation:
ation:ation:
ation:
- near heaters, next to a stove, direct
sunlight or any other heat sources;
- at locations with high humidity (e.g.
outdoors, bathroom), as metal parts
would be susceptible to corrosion
under such circumstances;
- near volatile or flammable materials
(e.g. gas, fuel, alcohol, paint, etc.),
in rooms which may have poor air
circulation (e.g. garages).
- Do not expose the appliance any
weather.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
• The installation to the mains supply
must conform to the local standards
and regulations.
• Improper connection may cause to an
electric shock
electric shockelectric shock
electric shock!
• Do not modify the appliance plug. If
the plug does not fit properly to the
outlet, let install a proper outlet by an
authorized specialist.
• The accessibility of the power plug
must be ensured to disconnect the
appliance from the power supply in
case of emergency.
• Make sure that the voltage supply
matches the specifications on the rat-
ing label before connecting.
• Connect the mains cable to a properly
installed and earthed wall outlet.
• If the plug after installation is not
accessible, a corresponding discon-
nect device must be available to meet
the relevant safety regulations.