Activate all valves into inflation position.
Fit the hose to the foot-pump.
To inflate your boat properly, the bottom side of
the foot-pump must rest on a flat ground.
Pump evenly to inflate rapidly.
DO NOT USE A COMPRESSOR OR A BOTTLE OF COMPRESSED AIR
You can us the electrical air pump ACCESS (ask your Dealer).
TO INFLATE THE BUOYANCY TUBE
• Insert the pump hose end piece (add the correct connecting tip for the semi-recessed valve)
• Inflate (pressure = 240 mb, reefer to PRESSURE section) making sure that each compartment is
equal. When correctly inflated, the internal bulkheads (a) are not visible.
NEVER COMPLETELY
INFLATE A
COMPARTMENT TO FULL
PRESSURE IF OTHER
COMPARTMENTS ARE
TOTALLY DEFLATED
Inflation is over: fit the valve caps tight (clockwise).
A slight air-leak before screwing the valve caps is normal.
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
To Next Page
Loading...
