BOMBARDIER SEA-DOO SPX 5838 1998 User Manual

• C

  Connie SwansonAug 7, 2025

  Why does the starter motor keep running on my BOMBARDIER Boat?

  

  Same questionReply

  • H

    heatherhutchinsonAug 7, 2025

    If the starter motor keeps running on your BOMBARDIER Boat, it could be due to several reasons. The solenoid winding might be shorted, or the solenoid contacts may have melted, requiring a solenoid replacement. A sticking or defective starter clutch could also be the culprit, in which case you should lubricate or replace it. Finally, the presence of salt water in the electrical box could be providing continuity; ensure the electrical box is watertight.

    

    Reply
• M

  mhillAug 14, 2025

  How to fix a starter that doesn't turn on my BOMBARDIER Boat?

  

  Same questionReply

  • E

    Emily MooreAug 15, 2025

    If the starter on your BOMBARDIER Boat does not turn, it could be due to a burnt 5A fuse. Check the wiring and replace the fuse if necessary. Another possible cause is poor contact at the battery terminals; clean and tighten them. Similarly, a poor battery ground cable connection should be cleaned and tightened. A weak battery can also prevent the starter from turning, so recharge or replace the battery. Finally, poor contact of the start/stop switch, safety lanyard switch, or solenoid could be the issue, in which case replacement is necessary.

    

    Reply
• M

  michele53Aug 22, 2025

  What to do if the starter turns but doesn't mesh with the ring gear on my BOMBARDIER SEA-DOO SPX 5838 1998?

  

  Same questionReply

  • D

    devonjenkinsAug 22, 2025

    If the starter turns, but the overrunning clutch pinion does not mesh with the ring gear on your BOMBARDIER Boat, there are several potential causes. The clutch pinion gear might be worn, or the clutch itself could be defective, both necessitating a clutch replacement. Poor movement of the clutch on the splines could also be the problem, which can be resolved by cleaning and correcting it. Additionally, a worn clutch bushing requires replacing the clutch. Lastly, a worn ring gear will need replacing the ring gear.

    

    Reply
• C

  conleyedwardAug 29, 2025

  Why does the starter engage but not crank the engine on my BOMBARDIER SEA-DOO SPX 5838 1998 Boat?

  

  Same questionReply

  • J

    Jacqueline GrossAug 30, 2025

    If the starter engages but doesn't crank the engine on your BOMBARDIER Boat, it could be due to poor brush contact, which requires straightening the commutator and brush. A burnt commutator needs turning in a lathe, while worn commutator segments require undercutting the mica. A shorted armature should be repaired or replaced. Weak brush spring tension means you should replace the brush holder or spring. A weak magnet requires replacing the yoke assembly. Worn bushings mean the clutch needs to be replaced. Lastly, a weak battery should be recharged or replaced.

    

    Reply

BOMBARDIER SEA-DOO SPX 5838 1998 Specifications

General

Manufacturer	Bombardier
Model	SEA-DOO SPX 5838
Year	1998
Type	Personal Watercraft
Horsepower	70 hp
Fuel Capacity	15.9 gallons
Seating Capacity	2 persons
Engine Type	2-stroke
Oil Capacity	3.2 quarts

Related product manuals

Sea-Doo Sport Boats SPORTSTER LE

100 pages

BOMBARDIER Sea-Doo RXT-X

196 pages

BOMBARDIER Sea-Doo Wake Pro

196 pages

SEA-DOO GTX RFI 5666 1998

47 pages

Invitation Triss Racer

23 pages