80102
Owner’s Manual
11
Right Side
Left Side
Fully Assembled View
Step 8
a) Align the holes of the upper hinges on the back
of the lid with the holes of the lower hinges on
the back of the body.
b) Insert one lid pin (LL) into each hole.
c) Insert one R pin (KK)
into the hole on the front
of the lid pin.
LL Lid pin 2 PCS
KK R pin 2 PCS
Step 9
a) Screw the gas cylinder counterclockwise into
the thread underneath the regulator valve until
it is in place.
b) Make certain the connection is secure and
conduct the leak test on page 12.
To Next Page
Loading...
