6
►The bag opening must lie flat on the welding wire. Otherwise the welding does not work
properly. Close the appliance lid. The press seal presses the bag onto the welding wire,
to create a smooth seam. Ensure that both corners of the appliance lid closed. If
necessary, press the upper cover again and so that the appliance lid clicks into place and
locks tightly. Press the Food button Mode Selection. If the choice is dry, the dry indicator
will light on. If the moist is chosen, the moist indicator will light on.
► Ensure that the weld seam is properly closed. A correct weld seam should be a
smooth, straight stripe without any creases.
► Fill the bag so that no food scraps or liquids can leak out during welding and get into
the appliance.
► Wait 15 seconds before sealing the next bag to allow the appliance to cool down.
Parts
1. Buttons:
1) Seal 2) Stop 3) Vac Seal 4) Dry
5) Moist 15) External interface switch/ Suction switch
2. Indicate Light:
16) Seal Indicator 17) Vac Seal Indicator
18) Dry Indicator 19) Moist Indicator
3. Other Parts:
6) Slide Cutter 7) Open Button 8) Vac Cotton
9) Vac Chamber 10) Heating Seal 11) Sealing Rubber Strip
12) Snap Joint 13) Roll holder 14) External Interface /Suction Interface
Functions &Vacuuming
To Next Page
Loading...
