66
Failure codes and what to do in case
of failure
If the programme won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine
door.
• Be sure that you switched off the machine by
pressing the Power On / Off button.
• Be sure that the water inlet lter and the
machine filters are not clogged.
If detergent residues are left in the detergent
compartment
Detergent has been added when the detergent
compartment was wet.
If water is left inside the machine at the end of
the programme
• The water drain hose is clogged or twisted.
• The lters are clogged.
• The programme is not nished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a
wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
ERROR CODE ERROR DESCRIPTION CONTROL
F5 Inadequate water supply • Make sure the water input tap is totally open and that
there is no water cut.
• Close the water input tap, separate the water input
hose from the tap and clean the filter at the connection
end of the hose.
• Restart your machine, contact the service if the error
resumes.
F3 Error of continuous water input • Close the tap.
• Contact the service.
F2 The waste water in the
machine cannot be discharged.
• Water discharge hose is clogged.
• The lters of your machine might be clogged.
• Power off-on your machine and activate the program
cancellation command.
• If the error continues, contact the service.
F8 Heater error Contact the service.
F1 Alarm is active against water
overflow
• Power off your machine and close the tap.
• Contact the service.
FE Faulty electronic card • Contact the service.
F7 Overheating error (tempera-
ture in the machine is too high)
• Contact the service.
F9 Divisor position error • Contact the service.
F6 Faulty heater sensor • Contact the service.
To Next Page
Loading...