Bosch ACS 653-P - Page 22

ACS 653, ACS 663 Service Manual
SP00D00624 2021-04-08 Robert Bosch GmbH
22
Introduction

7. Remove the refrigerant identifier filter
cover from the right side of the machine by
pressing it.
8. Remove the cap (3).
9. Place the contamination port (5) with its
o’ring and tighten at 15 Nm torque.
10. Place the Schrader valve in it (4) and tighten
at 0.35 Nm torque.
1
1
1
2
2

5
3
4
11. Remove the brass cap from the manifold (7)
and place the solenoid body (6). Tighten at
9 Nm torque.
12. Tighten the solenoid coil (6) at 4 Nm torque.
13. Fix the refrigerant identier (12) by 2 screws
as per Figure 1-14. Tighten at 0,4 Nm torque.

8
6
11
10
12
7
9
14. Remove the cap (8) from the manifold (7).
15. Fix the hose with tting coming with the
refrigerant identier in (8) and tighten at
7.5 Nm torque. Plug the other end of the
hose to tting (11) of refrigerant identier
(12) and tighten it.
16. Connect S17 faston harnesses to the
Solenoid faston contacts (6).
17. Connect the IDPWR end of power supply
harness from the power box to the connector
(10) of the refrigerant identier (12).