Bosch ACS 653-P - Page 82

ACS 653, ACS 663 Service Manual
SP00D00624 2021-04-08 Robert Bosch GmbH
82
Electrical
14. Insert the rear cover so that the 4 holes on
the sides the cover t into the 4 clips on the
machine. Push down to hook the rear cover.
15. Close the service rear door.
16. Reinstall the plastic frontal cover and
x it by 6 screws (1) and the 2 ones (2)
(see Figure 3-12).
17. Attach the outside high- (red) and low-side
(blue) service hoses. Tighten at 7.9 Nm
torque.
18. Switch on the machine.
19. Call up the Main Menu.
20. Select  icon.
21. Select  icon.
22. Select  " "
and .
23. Select  " 
and check if identifier field shown the
produce name and rmware.
24. Test the identier with a charge in service
hose and recovery.
7. Disconnect USB cable, power cable and
sample hose from refrigerant identier (4).
8. Unscrew the refrigerant identifier (4) by
2 screws (3).
9. Replace the refrigerant identier (4) and
sample hose (if needed).
10. Fix the refrigerant identifier (4) by
2 screws (3) taking care the lter position.
Tighten at 0,4 Nm torque.

11. Fix the hose with tting coming with the
refrigerant identier in (8) and tighten at
7.5 Nm torque. Plug the other end of the
hose to tting (7) of refrigerant identier (4)
and tighten it.
12. Connect the power cable to the connector
(6) of the refrigerant identier (4).
13. Connect the USB cable to the connector (5)
of the refrigerant identier (4).
8
7
3
3
6
4
5