Bosch AMAX 4000 - Page 119

Zone no. Address Default Zone no. Address Default
33 1464 0 49 1480 0
34 1465 0 50 1481 0
35 1466 0 51 1482 0
36 1467 0 52 1483 0
37 1468 0 53 1484 0
38 1469 0 54 1485 0
39 1470 0 55 1486 0
40 1471 0 56 1487 0
41 1472 0 57 1488 0
42 1473 0 58 1489 0
43 1474 0 59 1490 0
44 1475 0 60 1491 0
45 1476 0 61 1492 0
46 1477 0 62 1493 0
47 1478 0 63 1494 0
48 1479 0 64 1495 0
Value range: 2 = DX2010 zone, 3 = RF device (AMAX 4000), 15 = not used
Notice!
When a zone is assigned to an RF device (3), then the dedicated on-board zone is not
available.
Notice!
AMAX 2100 only: when keypad zones (1-4) are used, onboard zones (5-8) are disabled.
Notice!
Zones may be indicated on keypads with a number that differs from the zone number used for
programming and hardware input: Zones are indicated on LED/LCD keypads according to the
zone numbers. When one zone is disabled the indication number of all following (higher) zone
numbers will shift to a value decreased by one.
Examples:
AMAX 3000 / 4000:
In a one area or area 1 system keypad the zone number 17 is indicated on a 16 zone LED/LCD
keypad. After disabling zone 16 (or another one in range 1 to 16), zone number 17 is indicated
on the LED/LCD keypad as zone number 16.
AMAX 2100 / 3000 / 4000 Address Programming | en 119
Bosch Sicherheitsysteme GmbH Installation Guide 2014.11 | 02 | F.01U.267.112