RF Radion Receiver
General
The RADION receiver OP is a wireless receiver that connects the RADION wireless system
components to the AMAX panel 3000/4000. Features include the following:
– Cover and wall tamper protection
– RFID and configuration data contained in persistent memory
– Detection and reporting of radio frequency interference
– Support of two types of device enrollment
Installation
1. Disconnect all power supplies of the AMAX panel before installing B450.
2. Mount the receiver onto a wall in a location accessible for future maintenance using the
provided anchors and screws. For best reception, place the receiver in a central location
among the transmitters. In situations where there is a large distance between the
transmitter and receiver, it might be necessary to install receivers for optimum results.
Address Setting
Set the rotary switch to 1. The AMAX panel supports only one receiver.
Wiring
1. Connect the RADION receiver to the option bus.
2. Make sure that the cable distance to the AMAX panel doesn’t exceed 300 meters.
Status Indicator
The following table describes the system status indicator of the RFRC-OPT Radion receiver.
LED Condition Denotation
On Normal operation
Stable flash
Receiver is being programmed with the zone and transmitter IDs
from the AMAX panel.
Turns off momentarily Receiver has obtained a valid transmission from a RADION
transmitter.
3 quick flashes Communication error and/or self-test failure
Causes:
– A communication failure between the AMAX panel and the
receiver or
– An invalid address switch setting
Off Power failure or wiring failure
Table 5.13: RFRC-OPT Radion Receiver System Status Indicator
5.8
5.8.1
5.8.2
5.8.3
5.8.4
24 en | Optional Modules and Peripheral Devices AMAX 2100 / 3000 / 4000
2014.11 | 02 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
