4 When the keyfob RFID is asked for, press [*] for 3s to toggle between AUTO and
MANUAL mode.
When MANUAL is selected, enter the 9-digit RFID manually.
When AUTO is selected, trigger the RF device and the RFID is entered automatically.
RF Repeater
The AMAX panel identifies repeater devices by device RFID. AMAX Keypad programming
supports entering RFID automatically for Radion devices.
4 When the repeater RFID is asked for, press [*] for 3s to toggle between AUTO and
MANUAL mode.
When MANUAL is selected, enter the 9-digit RFID manually.
When AUTO is selected, trigger the RF device and the RFID is entered automatically.
RF Sensor Diagnose
The AMAX panel supports diagnostic feature for RF sensors. The keypad diagnose displays
signal/noise ratio distance. In dependency of the rating, the AMAX panel displays the numbers
of the RFID or RELOCATE. The AMAX panel keeps on polling for the signal and updates the
indication on a regular basis.
RF Repeater Diagnose
The AMAX panel supports diagnostic feature for RF repeaters. The keypad diagnose displays
signal/noise ratio distance. In dependency of the rating, the AMAX panel displays the numbers
of the RFID or RELOCATE. The AMAX panel keeps on polling for the signal and updates the
indication on a regular basis.
Clear RF devices
The AMAX panel provides the option to clear all RF devices in a step.
Key Programming
Programming with the ICP-EZPK Programming Key
The ICP-EZPK Programming Key allows you to save or copy programming information from
your AMAX panel. After saving information in the programming key, you can easily program
other AMAX panels with the same programming data. You can also use the programming key to
back up existing information.
4 If you have a new programming key, enter the programming mode, program the system as
required, and connect the programming key to the AMAX panel.
To connect the programming key:
4 Connect the programming key to the plug on top of the printed circuit board (PCB) of the
AMAX panel.
Notice!
Please note that the direction of the programming key should be consistent with the direction
marked on the PCB.
For example: How to copy data from the AMAX panel to the programming key:
1. Enter the installer code [1234] + [958] and press [#] to enter the programming mode.
2. Enter [962] + [#].
3. Copy the AMAX panel memory to the programming key.
7.8
AMAX 2100 / 3000 / 4000 Settings | en 79
Bosch Sicherheitsysteme GmbH Installation Guide 2014.11 | 02 | F.01U.267.112
To Next Page
Loading...
