Bosch AMAX 4000 - Page 99

Figure 8.16: Communication Setting - Setting the modem parameters
Notice!
The modem string settings in the above figure are only used when the default modem string is
not used.
If the default modem string is used, activate the parameter Using the default modem string
in the index sheet Link (after selecting Customer - Open Customer from the menu bar of the
A-Link Plus program and selecting the Control Panel Configuration index sheet).
In this case the values of above figure are ignored.
Instead the following string is used: AT&CI&D2X0&Q0S7=255S9=0+MS=B103B17
How to create a new customer
1. Select Customer –New Customer from the menu bar of the A-Link Plus program.
The Customer Information index sheet opens.
2. Enter relevant customer information. The Customer Number is mandatory.
3. Enter the telephone number connected to the AMAX panel in Control Panel Phone
Number. The AMAX panel telephone number does not need to be set for manual
connection.
AMAX 2100 / 3000 / 4000 Configuration | en 99
Bosch Sicherheitsysteme GmbH Installation Guide 2014.11 | 02 | F.01U.267.112