Bosch AMAX 4000 - Bypassing;isolating; Bypassing;unbypassing zones; How to bypass;unbypass a zone via text keypad

Faults and Tamper Conditions
Whenever a system fault or tamper condition occurs, the FAULT indicator flashes and the
keypad beeps.
Notice!
This operation is only possible in disarmed status.
System Fault or Tamper Analysis Mode via Text Keypad
To display the fault or tamper analysis for describing a system fault or tamper condition,
perform the following steps:
1. Enter your code + [2] [1] and press [#].
The system beeps twice and the fault or tamper conditions are displayed.
2.
Use [▲] and [▼] to display all fault or tamper conditions.
3. Press [#] to exit.
System Fault or Tamper Analysis Mode via LED/LCD Keypad
To display faults and tampers via a LED/LCD keypad, perform the following steps:
1. Enter your code + [2] [1] and press [#].
The system beeps twice. The FAULT indicator is extinguished and the STAY and AWAY
indicators flash. One of the number indicators is lit. Example: 2.
2.
Enter the number that is lit in the system. Example: 2.
One of the number indicators is lit. Example: 1.
3. Repeat step 2 until there is no number lit anymore.
4. Refer to the table Types of fault or tamper conditions for a description of the fault or
temper. The consecutively lit number indicators correspond to fault or tamper types.
Example: 2 – 1, which indicates a panel AC failure.
5. If necessary press [0] to return to step 2.
6. Press [#] to exit.
P The STAY and AWAY indicators are extinguished and the FAULT indicator is lit.
13
13.1
13.2
AMAX Faults and Tamper Conditions | en 29
Bosch Sicherheitsysteme GmbH User Guide 2014.09 | 03 | F.01U.295.569