Configuring the Control Panel
1. Select Customer – Open Customer from the menu bar of the A-link Plus program.
The Customer Information dialog opens.
2. Select the Control Panel Configuration index sheet.
3. Select the Control Panel Type.
Figure 5.4: Control Panel Configuration - Selecting the control panel type
1. Select the item Communication and Report manager – Receiver setting in the same
index sheet.
2. Make sure that the value for subscriber number 1 is the same as currently programmed in
AMAX panel as receiver 1.
3. The value is 000000, when the firmware of the AMAX panel was upgraded or when the
AMAX panel has factory settings.
5.5.6
AMAX 2100 / 3000 / 4000 Programming and Operating the AMAX System | en 17
Bosch Sicherheitsysteme GmbH Quick Start Manual 2014.11 | 02 | F.01U.309.297
To Next Page
Loading...
