Figure 5.5: AMAX panel configuration – subscriber number
1. Select the item Code manager in the same index sheet.
2. Make sure that the value for the parameter Installer code is the same as currently
programmed in the AMAX panel.
The value is 1234, when firmware of the AMAX panel was upgraded or when the AMAX panel
has factory settings.
18
en | Programming and Operating the AMAX System AMAX 2100 / 3000 / 4000
2014.11 | 02 | F.01U.309.297 Quick Start Manual Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
