Bosch AMAX 4000 - Page 15

Menu Items
Parameters / Description
Certification
Default
REM. ACCESS ARMED
14
REMOTE ACCESS
0-disable 1-enable
DOMESTIC CALL
15
0000000000
0-disable 1-enable
1
1
0
0 = Panel does not answer
1 - 13 = Number of rings until the control panel responds
14 = Call the control panel and allow the phone to ring no
more than twice and hang up. Wait a minimum of 8 sec and
call the control panel again. The control panel answers on
the first ring.
15 = Call the control panel and allow the phone to ring no
more than four times and then hang up. If you call again
within 45 sec, the control panel answers the call on the first
ring.
CALLBACK/DOMEST No
DOMESTIC No (1-4)
0-disable 1-enable
0
0-disable 1-enable
RPC IP/ PORT/ POLL
REMOTE PSTN ACCESS
RPC IP ADDRESS
CALLBACK/ DOMESTIC
RING TIMES
RPC ACCESS CODE
CALLBACK SETTING
RPC PORT 5 DIGIT!
CALLBACK PHONE No
RPC POLL: 1-15h
REMOTE IP ACCESS
CHANGE DOM PHO. No
Figure 5.3: Communications and Reporting Manager (continued)
60
03
0
1
Certification
Default
Menu Items
INSTALLER CODE
KEYFOB BUTTON3
2 CODE MANAGER
0-disable 1-enable
PAUSE T:100ms 1-15
1234
0-master 1 code
2-super code
KEYFOB ID: MANUAL
press* 3s for AUTO. 9 Digits
0-not used
4
1
0-disable 1-enable
CODE PERMISSIONS
KEYFOB ID: AUTO
0-disable 1-enable
2-stay arm
1
1
0-disable 1-enable
1
LEVEL 1 ACCESS
REC T.OUT:1-80sec
CODE INSIDE MACRO
2581
ARM/DISARM INSTAL.
CODE LENGTH
TAMPER RESET USER
DATE/TIME MASTER U
INPUT MACRO (1-3)
USER No.
4-arming code
press* 3s for MANUAL. Trigger device, RFID will be entered
CHANGE USER CODE
USER MACRO AUTH.
1-master 2 code
6-not used
3-basic code
5-duress code
Parameters / Description
1-output control
0-disable 1-enable
USER CODE IN AREA
USER CODE
USER CODE PRIORITY
0-disable 1-enable
2580
0
EN=0
FORCE CODE CHANGE
MACRO CONFIG
Figure 5.4: Code Manager
AMAX panel
Programming and operating the AMAX panel | en 15
Bosch Sicherheitssysteme GmbH Quick Installation Guide 2016.05 | 06 | F.01U.309.297