Bosch AMAX 4000 - Arming in STAY mode

2
EN=1
RF DEVICES / USER
RF REPEATER
SIREN BEEP ARM/DIS
1-4h
0-disable 1-enable
6-24h
0-no alarm
RF SUPERVISION
2-1h
00 - 15 00 = disable, 01 = most sensitive
5-12h
1
EN=0
2
4
12
RF KEYFOB PANIC AL
2-audible alarm
0-disabled
0-disable 1-enable
1
CLEAR CONFIRM
CLEAR CANCEL
REPEATERID: MANUAL
RF REPEATER DIAGN.
RF ZONE No:
RF SENSOR DIAGNOSE
1-silent alarm
press* 3s for MANUAL. Trigger device, RFID will be entered
CLR ALL RF DEVICES
REPEATER No: 1-8
2-24h
RF LOW BATT REPEAT
4-4h
3-2,5h
1-20min
REPEATER No: 1-8
press* 3s for AUTO. 9 Digits
REPEATER ID: AUTO
RF ZN MISSING = AL
RF JAM DETECT LEV.
0-disable
RF RECEIVER
0-disable 1-enable
0
7 RF MANAGER
RF SETTINGS
Default
Menu Items
Parameters / Description
Certification
Figure 5.10: RF Manager
Default
Certification
For Addresses, refer to Installation Guide
Parameters / Description
8 ADDR./KEY PROGR.
Menu Items
copy data from Panel to blue programming key
COPY DATA TO PANEL
COPY DATA TO KEY
ADDRESS PROGRAM
copy data from blue programming key to Panel
Figure 5.11: Address and Key Programming
Setting date and time
After the system is powered up, date and time must be set. Otherwise, the system displays a
fault.
1. Make sure that the system is in a disarmed status (the STAY and AWAY indicators are
disabled).
2. Enter the installer code [1234] + [51] and press [*] to get to CHANGE DATE / TIME.
3. Enter the current date and time by using the numeric keys and press [–] to save the data
end exit the programming mode
P Date and time are set.
Deleting a Zone
The zones 1-8 are enabled by default. The zone type for zone 1 is set as 03-delay 1, for zones
2-8 as 01-instant by default. Perform the following steps if you want to delete a zone.
1. Enter the installer code [1234] + [958] and press [#].
2. Select 3 ZONE MANAGER and press [#].
3. Select ADD/DELETE ZONES and press [#].
The system displays the next menu item: INPUT ZONE No.
4. Enter the number of the zone you want to delete (example: 1) and press [#].
The system displays the next menu item: ZONE MODULE SEL.
5. Select the correct zone module (default is 0-on board zone) and press [#].
The system displays the next menu item: ZONE FUNCTION.
5.4.2
5.4.3
AMAX panel Programming and operating the AMAX panel | en 21
Bosch Sicherheitssysteme GmbH Quick Installation Guide 2016.05 | 06 | F.01U.309.297