How to copy parameters from the key to the AMAX panel
1. Connect the programming key to the Printed Circuit Board (PCB) plug of the AMAX panel.
Please note that the direction of the programming key should be consistent with the
direction marked on the PCB.
2. Select text keypad installation menu ADDRESS / KEY PROGRAM – COPY DATA TO
PANEL and press [#].
After successfully copying the programming data in the programming key to the AMAX
panel, a confirmation tone occurs. Wrong prompt tone and display of Failure of Key
Parameters to AMAX Panel indicate a damage of the programming key data. In this case,
the data needs to be copied onto the AMAX panel again.
3. Unplug the programming key from the AMAX panel.
LED/LCD keypads can also be used to copy key parameters to the AMAX panel.
AMAX panel Settings | en 85
Bosch Sicherheitssysteme GmbH Installation Manual 2015.05 | 06 | F.01U.309.277
To Next Page
Loading...
