Bosch AMAX panel 2000 - Page 66

66 en | System Informations 2 AMAX panel 2000 / AMAX panel 2000 EN
F.01U.241.127 | V4 | 2011.12 Installation Manual Bosch Sicherheitssysteme GmbH
Table 8.1 System Report and Memory List
Option Bus Power fail 300 1 2 0E System status •
Option Bus Power
restore
300 3 2 0F System status •
RF Power fail 300 1 3 0E System status •
RF Power restore 300 3 3 0F System status •
Codepad fail 330 1 1,2 0E System status • •
Codepad fault restore 330 3 1,2 0F System status •
DX3010 fail 330 1 3 0E System status • •
DX3010 restore 330 3 3 0F System status •
DX4020/G fail 330 1 4 0E System status • •
DX4020/G restore 330 3 4 0F System status •
Code Retry Limit
exceeded
421 1 0 0EF7 System status • •
Communication fail 350 1 Destination
1-4
0EF7 System status • •
Communication restore 350 3 Destination
1-4
0FF7 System status •
Telephone/IP test report 602 1 0 0900 CFG Test
Config changed 306 1 0 050C System status •
Warning Device short 324 1 1,2 0112 System status • •
Warning Device
disconnect
324 1 1,2 0112 System status • •
Warning Device restore 324 3 1,2 0212 System status •
Phone Line fail 351 1 0 System status • •
Phone Line restore 351 3 0 System status •
Date Time set •
User Code change • •
Enter Program Mode •
Exit Program Mode
System reset •
Installer Access
authorized
••
Installer Access revoke • •
System restore •
Faults/Tamper
overridden
••