4 Keypad failure
4 1 - 16 Keypad 1 – 16 failure
5 System failure
5 1 Date time not set
6 Communication failure
6 1 Communication fault 1
6 2 Communication fault 2
6 3 Communication fault 3
6 4 Communication fault 4
6 5 Phone line fault
7 Tamper
7 1 System tamper
7 2 Keypad tamper
7 2 1 - 16 Keypad 1 - 16 tamper
7 3 Zone expansion module tamper
7 3 1 - 6 Zone expansion module 1 -6 tamper
7 4 Zone tamper DEOL
7 4 1 - 16 Sensor tamper DEOL
7 5 Zone type tamper
7 5 1 – 16 Zone type 1 – 16 tamper
7 6 Keypad Lock out
7 6 1 Keypad Lock out
7 7 RF receiver tamper
7 7 1 RF receiver tamper
7 8 RF repeater tamper
7 8 1 – 8 RF repeater tamper
8 External failure
8 1 - 16 External fault zone 1 - 16
Table 9.1: Types of fault or tamper conditions
* In case one or more faults occur in this category
Fault Description
1 - Accessory Module Failure
– Network/IP Module 1-2 Failure
Condition:
No communication with the DX4020 / ITS-DX4020G if DX4020 / ITS-DX4020G is available.
146
en | Troubleshooting AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
