Arming and Disarming the System
Arming the System
Notice!
When the number of incorrect code entries on the keypad
reaches a specified limit (configured by the installer), the
keypad will automatically lock for 180 seconds and an alarm is
reported. If the keypad is idle for one minute, the system will
automatically exit from any operational mode.
Arming in AWAY Mode
The AWAY Mode is used to arm the premises to detect a would-
be intruder, when you leave the premises and require that all
zones are activated in a ready state.
Keypad Arming
There are two methods to arm your system in AWAY mode.
Method 1:
4 Enter your code and press [#].
P The system beeps twice, the AWAY indicator flashes slowly
and exit time starts. After the exit time, the AWAY indicator
is lit.
Method 2 (Quick Arm):
4 Press and hold [#] until the system beeps twice.
P The AWAY indicator flashes slowly and exit time starts.
After the exit time, the AWAY indicator is lit.
Please contact your installer to enable/disable this function.
Master Keypad Arming
With a master keypad, either all areas or a single area can be
armed in AWAY mode.
3
3.1
3.1.1
16 en | Arming and Disarming the System AMAX panel
2015.05 | 04 | F.01U.295.569 Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
