Arming all areas
4 Enter your code, press [0] [0] and [#].
P The system beeps twice, the AWAY indicator flashes slowly
and exit time starts. After the exit time, the AWAY indicator
is lit and all areas are displayed as armed.
Arming a single area (direct AWAY arm)
Arming a single area with a master keypad is only possible for
users with the permission level master 1 or master 2.
4 Enter your code, press the 2-digit area number of the area
to be armed and press [#].
P The AWAY indicator flashes slowly and exit time starts.
After the exit time, the AWAY indicator is lit and the
selected area is displayed as armed.
4 Repeat if you want to arm multiple areas.
Please contact your installer to enable/disable this function.
Telephone Remote Arming
Notice!
Telephone remote arming is only possible when the system has
only one assigned area.
Users can use a telephone to arm the system.
1. Dial the control panel number.
The control panel answers the call and issues a long beep.
2. Press [#].
P When the panel receives the signal it confirms the arming of
the control panel with a high tone.
Please contact your installer to enable/disable this function.
Key Switch Arming
Users can use a key switch to arm the system.
4 Activate the key switch.
P The AWAY indicator flashes slowly and exit time starts.
After exit time, the AWAY indicator is lit.
AMAX panel Arming and Disarming the System | en 17
Bosch Sicherheitsysteme GmbH 2015.05 | 04 | F.01U.295.569
To Next Page
Loading...
