Arming all areas
4 Enter your code, press [0] [0] and [*].
P The system beeps twice, the STAY indicator flashes slowly
and exit time starts. After the exit time, the STAY indicator
is lit and all areas are displayed as armed.
Arming a single area (direct AWAY arm)
Arming a single area with a master keypad is only possible for
users with the permission level master 1 or master 2.
4 Enter your code, press the 2-digit area number of the area
to be armed and press [*].
P The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit and the selected area
is displayed as armed.
4 Repeat if you want to arm multiple areas.
Please contact your installer to enable/disable this function.
Key Switch Arming
Users can use a key switch to arm the system.
4 Activate the key switch.
P The STAY indicator flashes slowly and exit time starts. After
exit time, the STAY indicator is lit.
Please contact your installer to enable/disable this function.
RADION RF Keyfob Arming
Users can use a RADION RF four button keyfob to arm the
system via the third button.
4 Press the third button of the RADION RF four button
keyfob.
P The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit.
Please contact your installer to enable/disable this function.
Forced Arming
Arming the system when a zone is not sealed is known as forced
arming.
3.1.3
AMAX panel Arming and Disarming the System | en 19
Bosch Sicherheitsysteme GmbH 2015.05 | 04 | F.01U.295.569
To Next Page
Loading...
