– Or manual IP connection: Select “Network Connection” and click “Waiting for Callback” in
the “Connection” tab page. Then initiate IP connection from the alarm control panel with
keypad: Enter SUBSCRIBER NUMBER, press [5] [7] and then [#].
Figure 8.23: Network Connect
After successfully connected, RPS can execute multiple operations, including reading/writing
control panel parameters, remote arming/disarming, viewing log, etc.
After IP successfully connected, RPS will disconnect it with the alarm control panel after 5
minutes of idling if you select “Auto disconnect when idle connection exceeds 5 minutes”
option.
104 en | Configuration
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
