Bosch AMAX panel 4000 - Page 24

Wall Tamper
Jumper
Wall Tamper disabled
(Default position
)
R
B
G
Y
ADDR
Wall Tamper enabled
Jumper left on pin for storage only.
Figure 5.15: Wall Tamper Jumper
– Replace the inner cover.
– Place the spring from the hardware packet over the shaft of the tamper switch located on
the back of the receiver (see Figure 5.16).
Rear of Receiver
Figure 5.16: Rear of Receiver
Notice!
Cause of Hazard
Gently press the spring onto the tapered shaft. Do not force it down onto the shaft
Mounting the Receiver
• Determine the receiver’s mounting location.
• If not already done, remove the receiver’s cover (as shown in Figure 5.13).
• Place the receiver base on the wall at the desired mounting location and mark the two
mounting holes (see Figure 5.17).
24 en | Optional Modules and Peripheral Devices
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH