Address Setting
Notice!
When data bus address is changed, the module needs to be re-powered to make the new
address effective.
The receiver address option must have setting, Receiver #1.
AMAX panel 4000 supports Receiver 1 only, Receiver 2 is not supported.
No Jumper = Receiver # 1 (Default)
Jumper = Receiver # 2
Address Jumper
Jumper left on pin for storage only.
R
B
G
Y
ADDR
Figure 5.20: Address
Wiring
Connect RF3227E receiver to Bosch option Bus 1 or 2. The cable may not exceed 300 m.
Adding additional devices to the bus might reduce the maximum distance. Shielded cable is
not required. Do not use twisted pair wire.
Y
G
B
R
AUX 2+
AUX 2-
AUX 1-
AUX 1+
R
B
G
Y
RF3227E
Yellow
Green
Black (-)
Red (+)
Alarm Control Panel
Figure 5.21: Connecting RF3227E
5.6.3
5.6.4
26 en | Optional Modules and Peripheral Devices
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
