Figure 8.18: Control Panel Configuration
– d. Select “Communication and Report” in the “Control Panel Configuration” tab page. Set
the SUBSCRIBER NUMBER of receiver 1. The SUBSCRIBER NUMBER must be in
consistence with the SUBSCRIBER NUMBER of receiver 1 of the alarm control panel.
– e. Select “System Options” in the “Control Panel Configuration” tab page. Set installer
code. The “Installer Code” and its digits must be in consistence with the installer code
and its digits of the current alarm control panel.
– f. Click “Save”.
1. Connect
– Automatic dialing connection: Select “Modem Connection” in the “Connection” tab page
and click “Connect”.
98 en | Configuration
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
