Bosch B426 - Use Web-Based Configuration Menus; Device Information (Home) Page

Use web-based configuration menus
Notice!
Before proceeding, ensure that the web browser is not configured to use a proxy server.
Refer to the browser’s online help for instructions on disabling proxy service.
To use web-based configuration (B426 Configuration Pages):
1. Open an internet browser (Microsoft Internet Explorer 6 or higher, or Mozilla Firefox 3 or
higher), type in the B426’s IP address or hostname, and press [Enter]. (If Web and
Automation Security is enabled on the B426, you must type https:// instead of http://).
The B426’s Login page opens.
2. Enter the default password: B42V2 and click Login. The Device Information home page
opens.
3. Browse to the desired settings page and continue the parameters.
4. Click OK.
Notice!
Before browsing to a new settings page, you must click OK to save edited values.
5. Click Save & Execute to save and apply all changes to the device.
Notice!
Ensure that the address switch is set to its proper position for communication.
You should change your password after you complete these steps to secure module
configuration. Change the Web Access Password using the Maintenance page.
Device Information (home) page
The Device Information page shows basic information for the module in its main pane, and
provides links to the configuration web pages along the left-hand side.
Figure 5.2: Device Information page
Refer to the following sections for descriptions of the configuration web pages.
5.4
5.5
16 en | Configuration
Conettix Ethernet Communication
Module
2013.08 | 02 | F.01U.281.208 Installation and Operation Guide (UL) Bosch Security Systems, Inc.