Bosch B8512G - Page 151

Control Panels Keypad Installer menu | en 151
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
!
Caution!
Any points programmed as fire supervisory points are latching.
Point Index
B91x/B92x keypads configuration of Point Index
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [7] Points option. The keypad toggles between showing the point
index and point source for the selected point.
3. Use [PREV] or [NEXT] to go to the desired point, or enter the point number.
4. Press [ENTER] to edit the point and then [ENTER] to edit the index for the selected point.
5. Delete existing characters, if necessary, and then enter the new characters.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of Point Index
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [7] Points option. The keypad shows the index for the selected
point.
3. Use /[PREV] or /[NEXT] to go to the desired point, or enter the point number.
4. Press [Edit] to change the index.
5. Delete existing characters, if necessary, and then enter the new characters.
6. Press [Save].
7. When the keypad shows Parameter Saved, escape from the menu.
Point Source
B91x/B92x keypads configuration of Point Source
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [7] Points option. The keypad shows the index for the selected
point.
3. Use [PREV] or [NEXT] to go to the desired point, or enter the point number.
4. Press [ENTER] to edit the point and then press [NEXT] to go to the source option.
5. Press [ENTER] to edit the source for the selected point.
6. Use [PREV] or [NEXT] to scroll through the available options.
7. Press [ENTER] while viewing the desired source to save the programming.
8. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of Point Source
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [7] Points option. The keypad shows the point index for the selected
point.
3. Use /[PREV] or /[NEXT] to go to the desired point, or enter the point number.
4. Press [Source] to view and edit the source, and then press [Edit] to edit the source.
5. Use /[PREV] or /[NEXT] to scroll through the available options.
6. Press [Save] to save the programming.
7. When the keypad shows Parameter Saved, escape from the menu.