Bosch B8512G - Page 124

124 en | Keypad Installer menu Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
RESETZONEX
TAMPER
SDI2
PWR+/R
A/Y
B/G
COM/B
PWR+/R
A/Y
B/G
COM/B
24
25
26
27
28
29
23
26
SDIx
ire
olice
ting
RESETZONEX
TAMPER
SDI2
PWR+/R
A/Y
B/G
COM/B
PWR+/R
A/Y
B/G
COM/B
25
26
28
29
30
23
27
SDIx
ire
olice
ting
24
RESET
TAMPER
RESET
TAMPER
Exiting SERVICE MODE and returning to normal operation (slow pulsing Heartbeat LED)
4 Press and hold the control panel RESET button for approximately 5 seconds until the
Heartbeat LED turns off.
The control panel resets.
Conventions for this section
This guide to the keypad Installer menu provides instructions for using the keypad, based on
the following conventions:
– All instructions access the Installer menu from the Main Menu (Installer) option, not
while in SERVICE MODE.
– This section covers all compatible keypads. It provides specific steps for each keypad
style, when applicable.
– For simplicity, the keypad Installer menu tree and instructions combine the two-line
keypad number selections with the text and graphic steps of other keypads. For example,
this section does not have the B920 instructions of Press [2] for enhanced comm
parameters, and for the B930 instructions of Press [2] Enhanced Comm Parms. It has the
following more general instructions for all keypads: Press [2] Enhanced Comm Parms.
– Go to [1] Programming Menu > [1] Reporting > [2] Network > [2] Enhanced Comm
Parms.