Bosch B8512G - Disable Programming Menu; Wireless Menu; RF Point Menu> [1] Enroll Point RFID

152 en | Keypad Installer menu Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
5. Use /Previous or /Next to go the desired profile.
6. Press Save or Enter. The keypad shows Parameter saved.
7. Press Source or use /Next to go to the source option.
8. Press Edit or Enter to edit the source for the selected point.
9. Use /Previous or /Next to go the desired source.
10. Press Save or Enter. The keypad shows Parameter saved.
11. Press Area or use /Next to go to the area option.
12. Press Edit or Enter to edit the area for the selected point.
13. Use /Previous or /Next to go the desired area.
14. Press Save or Enter. The keypad shows Parameter saved.
15. Press Name or use /Next to go to the source option.
16. Press Edit or Enter to edit the name for the selected point.
17. Delete the existing characters, if necessary, and enter the new characters.
18. Press Save or Enter. The keypad shows Parameter saved.
20.1.17 [8] Disable Programming menu
The Keypad Installer menu is enabled by default. When enabled, the Service User (Authority
Level 15) has authority to access the menus. If you disable Keypad Programming, the Service
User cannot access the menus. In this menu, you can disable Keypad Programming.
Notice!
You can continue using the current programming session. Disabling Keypad Programming
applies once you exit the current session.
Keypad Programming
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [8] Disable. The keypad shows that programming is
enabled.
3. Depending on keypad model:
Press Edit and then press No.
-or-
Press Enter and then press Next to view the No option.
4. Press Save or Enter. The keypad shows Parameter saved.
5. Escape from the menu.
20.2 [2] Wireless menu
Use the Wireless menu to add, replace, remove, and diagnose points and repeaters.
20.2.1 [1] RF Point Menu> [1] Enroll Point RFID
Once the control panel has points programmed as Wireless, you can enroll RF devices into the
system as a specified wireless points. In this menu, you can enroll RFID points.
Enroll point RFID
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [2] Wireless > [1] RF Point Menu > [1] Enroll point RFID. The keypad lists any
enrolled points.
3. Use /Previous or /Next to scroll through the list of wireless points, and go to the
point for which you want to enroll a device, or simply enter the point number.