Bosch B8512G - Test

70 en | Off-board outputs Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
For detailed instructions, refer to the corresponding document listed in Related
documentation, page 13.
11.2.1 Installation and control panel wiring (B600)
Calculate power consumption
Make sure that there is enough power for the module and the other powered devices that you
want to connect to the system.
Refer to On-board outputs, page 65.
!
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
result in personal injury and/or equipment damage.
Installing the module
1. For retrofit applications, remove the terminal strip from the module.
2. Hold the module mounting brackets onto the inside of the enclosure. Match the bracket
holes to a 3-hole mounting pattern on the enclosure
3. Use the supplied mounting screws to secure the module.
Wiring the module to the control panel
SDI2
COM
PWR ZX2
IN
ZX2
OUT
ZX1
IN
ZX1
OUT
COM
B
SDI B
G
SDI A
Y
PWR
R
ZONEX
RESETZONEX
TAMPER
SDI2
PWR+/R
A/Y
B/G
COM/B
PWR+/R
A/Y
B/G
COM/B
24
25
26
27
28
29
23
26
SDIx
ire
1
2
Callout ᅳ Description
1 ᅳ ZONEX connection cable
2 ᅳ SDI interconnect cable