Bosch B9512G - Page 6

6 en | Table of contents Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
13.3.1 D8125 expansion 80
13.3.2 D8128D OctoPOPIT Eight-point Expander 81
13.4 Test off-board points 81
13.5 Extra Point events 82
13.6 Missing point conditions 82
14
Wireless modules 83
14.1 B810 receiver 83
14.1.1 SDI2 address settings 83
14.1.2 Supervision 83
14.1.3 Installation and control panel wiring (B810) 83
14.2 B820 SDI2 Inovonics Interface Module 84
14.2.1 SDI2 address settings 84
14.2.2 Supervision 84
14.2.3 Installation and control panel wiring (B820) 84
15
Access control 86
15.1 B901 86
15.1.1 Address settings 86
15.1.2 Supervision 86
15.1.3 Installation and control panel wiring (B901) 86
15.2 D9210C 87
15.3 Card reader wiring 87
16
Program and test the control panel 88
16.1 Program the control panel 88
16.2 Perform walk tests 88
16.2.1 Fire walk test 88
16.2.2 Intrusion walk test 88
16.2.3 Service walk test 89
16.2.4 Invisible walk test 89
17
Control panel board overview 91
18
System wiring diagrams 93
18.1 Power supply side wiring 94
18.2 Input points wiring with D125B, D130, or D129 95
18.3 Input points wiring with or without EOL resistors 95
18.4 SDI and ZONEX wiring 96
18.5 SDI2 devices general system wiring 98
18.5.1 SDI2 bus wiring recommendations 98
18.6 2-wire smoke wiring (D125B) 100
19
Approved applications 102
19.1 Optional compatible equipment 102
19.1.1 Burglar applications 102
19.1.2 Bank safe and vault applications 102
19.1.3 Fire applications 105
19.1.4 Enclosures 107
19.2 Combination fire and intrusion alarm systems 107
19.3 Compatible UL listed components 107
19.4 Standby battery requirements and calculations 110
19.4.1 Household Fire Warning equipment 113
19.5 UL 365 - Police Station Connected Burglar Alarm Units and Systems 114
19.6 UL 636 - Holdup Alarm Units and System 114