Control Panel User Configuration | en 157
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
– Disable (-) - Disable this function panel wide regardless of the user's authority level.
– Enable (E) - Enable this function panel wide without requiring a passcode.
– Passcode (P) - Require a passcode to enable this function panel wide.
This function allows the user to change the Time from the keypad to make adjustments to
Skeds. This is a panel wide function that can be executed from any keypad assigned to an area
where the user has authority.
RPS Menu Location
User Configuration > User Keypad Functions > Change Skeds
9.3.31 Walk Test All Invisible Burg Points
Default:P
Selections: - , E, P
– Disable (-) - Disable this function panel wide regardless of the user's authority level.
– Enable (E) - Enable this function panel wide without requiring a passcode.
– Passcode (P) - Require a passcode to enable this function panel wide.
This function allows a user with Invisible Walk Test authority to test invisible intrusion points
that are within the scope of the keypad without sending a report to the central station.
Invisible points must have the Invisible Point parameter set to Yes.
24-Hour points left off-normal when exiting the Invisible Walk Test are bypassed. A trouble
tone sounds until it is silenced. The keypads will alternate text with the Bypass indications.
RPS Menu Location
User Configuration > User Keypad Functions > Walk Test All Invisible Burg Points
9.3.32 Silence Function
Default:E
Selections:
– Enable (E) - Enable this function panel wide without requiring a passcode.
– Passcode (P) - Require a passcode to enable this function panel wide.
This parameter enables or disables the silence function.
RPS Menu Location
User Configuration > User (Keypad) Functions > Silence Function
9.3.33 Custom Function
Default:Passcode (P)
Selections: - , E, P
– Disable (-) - Disable this function panel wide regardless of the user's authority level.
– Enable (E) - Enable this function panel wide without requiring a passcode.
– Passcode (P) - Require a passcode to enable this function panel wide.
This function sets whether a passcode will be required (or not) when attempting to access a
Custom Function from the Shortcut Menu, A-Key, B-Key, C-Key, or a Keyfob.
The B9512G supports Custom Function 128 to 159.
The B8512G supports Custom Function 128 to 135.
RPS Menu Location
User Configuration > User Keypad Functions > Custom function
9.3.34 Keypad Programming
Default:P
Selections: - , E, P
– Disable (-) - Disable this function panel wide regardless of the user's authority level.
– Enable (E) - Enable this function panel wide without requiring a passcode.
To Next Page
Loading...
