Bosch B9512G - Report Routing

46 en | Panel Wide Parameters Control Panel
2017.03 | 09 | F.01U.303.998 Program Entry Guide Bosch Security Systems, Inc.
8. Burglar Reports: Burg Restore (after Trouble), Missing Alarm, Trouble Report, Missing
Trouble, Point Bus Fail, Point Bus Restoral, Alarm Restore, Supervision Missing,
Unverified Event.
9. User Reports: Forced Point, Was Force Armed, Forced Close, Forced Close Part On
Instant, Forced Close Part On Delay.
Diagnostic Reports: Service Smoke Detector, Service Smoke Detector Restore.
Output Reports: Sensor Reset, Output Set, Output Reset.
Auto Function Reports: Sked Executed, Sked Changed, Fail to Execute (Sked).
Point Reports: Bypass, Bypass Restore.
User Change Reports: Change Level.
10. Burglar Reports: User Code Tamper.
User Reports: Fail to Open, Fail to Close, Extend Close Time, Opening Report, Closing
Report, Point Opening, Point Closing, Part On Instant, Part On Delay.
Test Reports: Status Report, Test Report.
Diagnostic Reports: SDI2 Device Restoral, Phone Line Restoral, AC Restoral, Checksum
Fail, Network Fail (and Restoral), Network Condition, RF Interference (and Restore),
Equipment Fail (and Restore), Personal Notification Communication Trouble (and
Restore).
RPS Reports: Event Log Threshold, Event Log Overflow, Parameters Changed, RPS
Access OK, RPS Access Fail, Remote Reset, Program Access OK, Program Access Fail.
Point Reports: Service Start, Service End, Fire Walk Start, Fire Walk End, Walk Test Start,
Walk Test End, Extra Point, RF Low Battery, RF Battery Restore.
User Change Reports: Date Changed, Time Changed, Delete User, User Code Change,
Area Watch, Keyfob Assigned, Keyfob Removed, Change Level.
Access Reports: Access Granted, No Entry, Door Left Open, Cycle Door, Door Unlocked,
Door Secure, Door Request, Door Locked.
See also
– Report Routing, page 46
– Communicator, overview, page 58
– On Board Ethernet (IP) Communicator, page 31
– Enhanced Communication, page 62
– Cellular Plug-in Module, page 36
– Configuring for Cellular Service, page 280
– Phone and Phone Parameters, page 28
– (B42x) IP Communicator, page 239
– B450 cellular, page 246
3.9 Report Routing
Default:
Report Category
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Fire Reports, page 47 Yes Yes Yes Custom
Gas Reports, page 48 Yes Yes Yes Custom
Burglar Reports, page 48 Yes Yes Yes Custom
Personal Emergency Reports,
page 48
Yes Yes Yes Custom