Bosch B9512G - Page 47

Control Panel Panel Wide Parameters | en 47
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
Report Category
Route Group 1 Route Group 2 Route Group 3 Route Group 4
User Reports, page 48 Custom Custom Custom Custom
Test Reports, page 49 Yes Yes Yes No
Diagnostic Reports, page
49
Custom Custom Custom Custom
Output Reports, page 50 Yes Yes Yes Custom
Auto Function Reports, page
50
Yes Yes Yes No
RPS Reports, page 50 Custom Custom Custom No
Point Reports, page 50 Yes Yes Yes No
User Change Reports, page
50
Yes Yes Yes Custom
Access Reports Yes Yes Yes Yes
Selections:
Yes - assign all of the reports in this category to the Route Group.
No - assign all of the reports in this category to the Route Group.
Custom - you can not select Custom. Custom shows for a category when at least one of the
reports in the category is configured individually.
Notice!
Configuration for individual reports lost on change from Custom to Yes or No
When Custom appears for a category of reports, it indicates that not all of the reports are set
the same (all Yes or all No). The reports have been set individually.
If you change the reports for a category from Custom to Yes or No, the configuration for the
individual reports in the category is lost. To individually re-assign reports from a report
category to a Route Group, you must click on the report category in the menu tree, Fire
Reports, page 51 for example.
RPS Menu Location
Panel Wide Parameters > Report Routing
Fire Reports
Reports in the Fire category:
– Fire Alarm
– Fire Restoral (After Alarm)
– Fire Missing
– Fire Trouble
– Fire Supervision
– Fire Restoral (After Trouble)
– Fire Cancel
– Fire Supervision Missing
– Fire Supervision Restoral
To individually assign reports from the Fire category to a Route Group, click Fire Reports, page
51 in the menu tree.